Multi Protect Wood-Aluminium-PVC paint 2.5L Pebble grey RAL 7045
€89.99(-10%)€80.99
Multi Protect Wood-Aluminium-PVC paint 2.5L Pebble grey RAL 7045 is available to buy in increments of 1
Multi Protect paint for doors, frames, cladding... can be used to paint all exterior home surfaces. Available in a range of colors, including RAL shades and a few matte shades, it adheres without undercoat and with minimal preparation to wood, aluminum or PVC substrates, so you can even out your building's various surfaces. 8-year warranty*.
Doors, frames, shutters, gates, fences,
beams, pergolas, carports, railings... in wood
wood, aluminum or PVC. Also suitable for wood or aluminum garden furniture.
New/rough surfaces or surfaces to be renovated (already
varnished, solvent-based or water-based).
or water-based).
Do not apply to soft plastics
nylon, polypropylene, polyethylene, polycarbonate
polyethylene, polycarbonate, Plexiglas,
floors, surfaces where water stagnates, masonry
oiled or waxed wood.
As desired or depending on project configuration :
Brush
Roller
Spray gun
PREPARATION
The surface to be painted must be clean, dry and non-greasy. Always round off corners and sharp edges to ensure even coverage.
NEW or unfinished wood: lightly sand the surface with
surface with 150-grit sandpaper and remove dust.
previously painted, varnished or stained wood :
remove old, loose finishes. Wash with a soda-based cleaner, rinse and allow to dry. If the paint is old
sand and remove dust.
ALUMINIUM
and PVC: wash thoroughly with a soda-based cleaner, then rinse. Sand lightly with 180 grain sandpaper, then remove dust.
APPLICATION
Ideal application conditions: between 12 and 25°C in dry, draught-free conditions.
Stir Multi Protect Door & Chassis Paint vigorously before use, using a long, wide stirring rod, paying particular attention to the bottom of the can, to homogenize the product.
Apply evenly, without excess thickness, using a brush, roller or spray gun (3 passes) and leave to dry for 4 hours.
Sand lightly with 240-grit sandpaper and apply 2nd coat. Allow to dry for 4 hours, then sand lightly with 240-grit paper between coats.
Remove as much product as possible from tools
use. Do not dispose of residues or wash water/solvents down the sink, toilet, drain, garbage can, etc., to avoid release into the environment.
TIPS
Do not apply to a hot/frozen surface, and avoid exposure to strong sunlight/rain immediately after application.
For spray application, allow for dilution (max 10% water) and application in 3 thinner coats.
When using several pots, avoid changing pots in the middle of a surface. Plan to mix them or dedicate one can to a single coat or a whole face.
Avoid wasting paint: estimate how much paint you need. Close unfinished cans so you can reuse paint. Reusing paint is a good way of reducing the environmental impact of products over their entire life cycle.
Close packaging after use.
Final properties are obtained after a few days drying.
When using by spraying, be sure to wear appropriate gloves and clothing, and avoid breathing mists.
8-YEAR WARRANTY
*The 8-year warranty covers :
Vertical supports, in accordance with preparation and application instructions.
The warranty is limited to reimbursement of the product (on presentation of the can and sales receipt) and concerns only the appearance of the paint.
